CUT 160H AND 100H IGBT Inverter Technology

CUT 160H AND 100H (J)

IGBT module inverter technology.
Low cost cutting with high stable and stiff arc, which brings you smooth cutting notch and small cutting angle (ISO9013:2002(E) standard 4-5); less slag and warping; smaller heat affected area.
Pilot Arc Start increases cutting efficiency.
Conveniently and quickly cut metal plate.
Built-in air filter and regulator.
Equipped with over/under voltage, as well as insufficient compressor air pressure protection.
Smooth cutting surface with high cutting speed.
Widely used in cutting carbon steel, stainless steel, copper, cast iron and aluminum, etc.
Strengthened and protection on cutting torch connector largely enhances operator’s safety.
International Standard IEC 60974-1.

MODEL	CUT-100H	CUT-160H
Input power source	AC415V±15% 50/60Hz	3~AC380V±15%, 50/60Hz
Rated input current (A)	21.4	41.1
Rated input power capacity (kVA)	15.2	29.2
Power factor	0.9	0.9
Output current (A)	88V-120V	30-160
No-load voltage (V)	DC315V	320
Rated duty cycle (%) @40°C	100	80
Arc starting	HF	HF
Quality cutting thickness (mm)	25	45
Max cutting thickness (mm)	45	60
Recommended compressor capacity (L/min)	170	170
Recommended cutting pressure (Kg/cm)	4-6	4-6
Output characteristics	CC	CC
Efficiency (%)	85	85
Protection class	IP21S	IP21S
Insulation class	F	F
Dimensions (mm)	676 × 333 × 712	676 × 333 × 712
Weight (Kg)	24	56